R****s 发帖数: 635 | 1 00 Mercury sable. 前轮司机一侧CV boot破了,
润滑油全流出来了,黑黑的洒得到处都是。
打算DIY把CV joint axle换掉。
因为经常DIY,基本工具都有,在网上订了一个25"的break bar,20刀。
另外还定了一个CV joint axle,大概55刀.
还从local 店买了一套前刹的break pad,
一个wheel hub assembly (担心wheel bearing也坏了)
到时有必要顺手换上。
估计还需要一下一些工具:
1) 30mm加长套筒,用来卸wheel hub的螺丝。
2) bearing puller,如果换wheel hub,需要用。
3) 一种鱼叉形的工具,不知道名字,用来卸lower control arm的.
打算精心准备两周,larbor day的长周末动手,之后来报告并贴pp。
各位有经验的帮忙看看,有什么要注意的吗?
thanks |
l****n 发帖数: 723 | 2 多准备一些WD40, PBlaster之类的东西。
祝好运并记得汇报。 |
l******e 发帖数: 3426 | |
l******e 发帖数: 3426 | |
i*******d 发帖数: 623 | |
s*******t 发帖数: 2896 | 6 我奇怪为啥司机侧的悬挂容易坏,谁能解释一下?
如果拆ball joint之类的,还是借个puller吧,拧的那种。 |
s***a 发帖数: 299 | |
D*******l 发帖数: 5462 | 8 司机太重了。
【在 s*******t 的大作中提到】 : 我奇怪为啥司机侧的悬挂容易坏,谁能解释一下? : 如果拆ball joint之类的,还是借个puller吧,拧的那种。
|
f**w 发帖数: 377 | |
c******y 发帖数: 115 | |
u****a 发帖数: 568 | 11 If possible, don't use the ball joint separator (一种鱼叉形的工具,不知道名
字,用来卸lower control arm的). This thing will damage the ball joint boot.
loosen the bolt that hold the ball joint and use a big hammer to hit the
control arm so the ball joint pin will pop loose.Then you can use the
separator to pry the ball joint pin out of the wheel hub assemble. |
P*B 发帖数: 944 | 12 顶这个
【在 c******y 的大作中提到】 : 备一个torch
|
l****n 发帖数: 723 | 13 如果你买seprator fork, 做好更换ball joint的准备, 十次有几次那个fork会把
boot 弄破。 有一专门的puller, 那种会好很多。 |