s******s
发帖数: 1602 | 1 前两天买的旧车Toyota minivan,只有一套钥匙,朋友说去沃尔玛可以配,可是去了人家
说这种钥匙配不了,只能去dealer配,我也不太明白,请问大家有知道那里可以配的吗?还
是说必须得去dealer配?大概得多少钱?
谢谢! | M***s
发帖数: 8769 | 2 ebay 买钥匙，去walmart或者homedepot cut，然后自己program | s******s
发帖数: 1602 | 3 沃尔玛那个人说里面有sensor(我听像这个词),他们配不了,让去厂家配,我也不懂了.
我网上查了查,你的意思是不是去网上买这种钥匙,然后拿去配? 自己program是什么意思?
谢谢!
【在 M***s 的大作中提到】
: ebay 买钥匙，去walmart或者homedepot cut，然后自己program
| M***s
发帖数: 8769 | 4 找个老师傅，新来的不懂，你就说只要你cut，不要你program，还是不给你弄得话就换
一家
一般只cut不能收钱，所以他们也不是很愿意做，实在找不到就去locksmith，花1-2块
钱cut就行了
【在 s******s 的大作中提到】
: 沃尔玛那个人说里面有sensor(我听像这个词),他们配不了,让去厂家配,我也不懂了.
: 我网上查了查,你的意思是不是去网上买这种钥匙,然后拿去配? 自己program是什么意思?
: 谢谢!
| i******t
发帖数: 11048 | 5 如果你的车配备了secrurity chip这个自己干不了
要dealer给你配。
意思?
【在 s******s 的大作中提到】
: 沃尔玛那个人说里面有sensor(我听像这个词),他们配不了,让去厂家配,我也不懂了.
: 我网上查了查,你的意思是不是去网上买这种钥匙,然后拿去配? 自己program是什么意思?
: 谢谢!
| s******s
发帖数: 1602 | 6 我这买的是二手车,买的时候也没问.什么是security chip?怎么能看出来有没有? 我怎
么在ebay上买钥匙?
【在 i******t 的大作中提到】
: 如果你的车配备了secrurity chip这个自己干不了
: 要dealer给你配。
:
: 意思?
| M***s
发帖数: 8769 | 7 买钥匙
http://www.ebay.com/itm/NEW-TOYOTA-TRANSPONDER-CHIP-UNCUT-IGNIT
program
Here is how to program the remote and transponder key. This will work on
some other Toyota models as well. In fact, the remote instructions were
taken from a Toyota Sienna web site. It took me a couple of tries to do this
, but it's not that hard. Just be careful and follow the instructions.
The key:
1. Simultaneously depress and release the brake and
accelerator pedals 1 time (one instruction kind of hints that you
should hold the pedals down while you insert the master key, the next
step).
2. Insert the master key in the ignition, but do not turn it.
3. Within 15 seconds press & release the accelerator pedal 5 times.
4. Then within 20 seconds press & release the brake pedal 6 times.
5. Within 10 seconds remove the master key, and insert the new key.
6. Within 10 seconds press & release the accelerator 1 time.
7. The security light will stay off after 60 to 80 seconds indicating the re
-programming was successful.
8. Remove the new key, and depress & release the brake pedal
1 time.
The Remote:
1. Start with the following conditions:
a) Key is out of the ignition
b) Driver door is open (all other doors are closed)
c) Driver door is unlocked (other door locks don't matter)
2. Insert the key into the ignition (don't turn it) and pull it out.
3. Perform these steps within 40 seconds:
a)Using the power lock/unlock switch on the driver's door (with the driver's
door still open and unlocked), perform 5 lock/unlock cycles starting with
lock. A lock/unlock cycle consists of pressing the power lock switch,
followed by pressing the power unlock switch on the driver's door panel. Use
an even pace and try to go relatively fast.
b)Close, then open, the driver's door.
4. Perform these steps within 40 seconds:
a) Using the power lock/unlock switch on the driver's door, perform 5 lock/
unlock cycles starting with lock, as you did previously.
b) Turn the ignition to "ON" (as far as you can go without cranking your
engine), then back to "OFF".
c) Again, turn the ignition to "ON" (as far as you can go without cranking
your engine), then back to "OFF".
d) Remove the key from the ignition.
5. Within 3 seconds, the power door locks should cycle (lock then unlock)
automatically, indicating successful entry into programming mode. Return to
step 1 if the locks do not cycle at this point.
6. Perform these steps within 40 seconds:
a) Press the lock and unlock buttons on the transmitter (the remote)
simultaneously for 1 second.
b) Immediately after letting go of the lock and unlock buttons, hit the lock
button by itself and hold it for 2 seconds. Within 3 seconds, the door
locks should cycle (lock then unlock) once indicating successful programming
. If the door locks don't cycle, or cycle twice, repeat steps 6a and 6b, as
this means the remote has not been accepted.
c) Repeat steps 6a and 6b for each transmitter that will operate the vehicle
, including any old transmitters.
7. Close driver's door. | s******s
发帖数: 1602 | 8 谢谢，我准备照你说的这个自己弄一下．
this
【在 M***s 的大作中提到】
: 买钥匙
: http://www.ebay.com/itm/NEW-TOYOTA-TRANSPONDER-CHIP-UNCUT-IGNIT
: program
: Here is how to program the remote and transponder key. This will work on
: some other Toyota models as well. In fact, the remote instructions were
: taken from a Toyota Sienna web site. It took me a couple of tries to do this
: , but it's not that hard. Just be careful and follow the instructions.
: The key:
: 1. Simultaneously depress and release the brake and
: accelerator pedals 1 time (one instruction kind of hints that you
| a******e
发帖数: 710 | 9 这篇应该m，置顶
this
【在 M***s 的大作中提到】
: 买钥匙
: http://www.ebay.com/itm/NEW-TOYOTA-TRANSPONDER-CHIP-UNCUT-IGNIT
: program
: Here is how to program the remote and transponder key. This will work on
: some other Toyota models as well. In fact, the remote instructions were
: taken from a Toyota Sienna web site. It took me a couple of tries to do this
: , but it's not that hard. Just be careful and follow the instructions.
: The key:
: 1. Simultaneously depress and release the brake and
: accelerator pedals 1 time (one instruction kind of hints that you
| s******s
发帖数: 1602 | 10 终于把钥匙买来了，遥控也买了，遥控倒是给弄好了今天．
话说钥匙去了沃尔玛也不给ＣＵＴ，结果离家最近的ＫＭＡＲＴ给免费ＣＵＴ了今天，
可是我照着这个说明弄了半天也不行，到最后那个安全灯也没有闪，所以还是启动不了
车．我在ＹＯＵＴＵＢＥ上找了ＶＩＤＥＯ看了，说的差不多，试了也不行？请问你觉
得我那里有可能出错了？
话说去了ＤＥＡＬＥＲ问了ＰＲＯＧＲＡＭ要六十几刀，ＣＵＴ钥匙要六十刀，加起来
一百多刀一把钥匙，ＡＣＥ干这个要八十刀，ＬＯＣＫＳＭＩＴＨ还没问．现在就想自
己试试能成功就能省点钱啊．
谢谢！
this
【在 M***s 的大作中提到】
: 买钥匙
: http://www.ebay.com/itm/NEW-TOYOTA-TRANSPONDER-CHIP-UNCUT-IGNIT
: program
: Here is how to program the remote and transponder key. This will work on
: some other Toyota models as well. In fact, the remote instructions were
: taken from a Toyota Sienna web site. It took me a couple of tries to do this
: , but it's not that hard. Just be careful and follow the instructions.
: The key:
: 1. Simultaneously depress and release the brake and
: accelerator pedals 1 time (one instruction kind of hints that you
| e*****e
发帖数: 543 | 11 program找你的车对应的manual,如果manual上没有,估计就只能delaer才能搞了.
什么ACE,locksmith也没戏.
【在 s******s 的大作中提到】
: 终于把钥匙买来了，遥控也买了，遥控倒是给弄好了今天．
: 话说钥匙去了沃尔玛也不给ＣＵＴ，结果离家最近的ＫＭＡＲＴ给免费ＣＵＴ了今天，
: 可是我照着这个说明弄了半天也不行，到最后那个安全灯也没有闪，所以还是启动不了
: 车．我在ＹＯＵＴＵＢＥ上找了ＶＩＤＥＯ看了，说的差不多，试了也不行？请问你觉
: 得我那里有可能出错了？
: 话说去了ＤＥＡＬＥＲ问了ＰＲＯＧＲＡＭ要六十几刀，ＣＵＴ钥匙要六十刀，加起来
: 一百多刀一把钥匙，ＡＣＥ干这个要八十刀，ＬＯＣＫＳＭＩＴＨ还没问．现在就想自
: 己试试能成功就能省点钱啊．
: 谢谢！
:
|
|
