z****g 发帖数: 2128 | 1 需要什么额外的工具?
目前有
1)2个剪刀jack,一个bottlejack
2)2个jack stand
3)breaker bar,3/8的
我能想到的是,购置:
1)3/4的breaker bar,加一个36mm的socket
2)homedepot买根水管
只是不知道难度如何?我就怕我动手了,装到一半搞不定就二了。 |
d***8 发帖数: 2039 | |
d***8 发帖数: 2039 | |
z****g 发帖数: 2128 | 4 不是,就是开车的时候,40-60mph的时候
加速的时候,车子震动明显。
看网上说80%是axle坏了。
【在 d***8 的大作中提到】 : 你是一个axle上的两个boots都坏了?
|
d***8 发帖数: 2039 | 5 你这太搞了。
有无数原因引起震动,换axle是最难搞的一个原因。
【在 z****g 的大作中提到】 : 不是,就是开车的时候,40-60mph的时候 : 加速的时候,车子震动明显。 : 看网上说80%是axle坏了。
|
f****t 发帖数: 15913 | 6 I did it yesterday. Replaced driver side drive axle assembly by myself.
Took 2 hours. I used a chisel to pry the axle out of the transmission block
. I also used 2 bungee cords to hang the rotor/steering knucle.
Depending on your car, you may not need to remove ball joint. I did not
remove mine. You also need a torque wrench.
My CV boot was broken. I did not bother to replace the boot. Just replace
the whole axle. The new axle is made by A1 cardone (high quality). The
axle costed me $93.
【在 z****g 的大作中提到】 : 需要什么额外的工具? : 目前有 : 1)2个剪刀jack,一个bottlejack : 2)2个jack stand : 3)breaker bar,3/8的 : 我能想到的是,购置: : 1)3/4的breaker bar,加一个36mm的socket : 2)homedepot买根水管 : 只是不知道难度如何?我就怕我动手了,装到一半搞不定就二了。
|
d***8 发帖数: 2039 | 7 那个ball joint fork 是用来叉住axle,在往外hammer的。不是用来分离ball joint
的。
block
replace
【在 f****t 的大作中提到】 : I did it yesterday. Replaced driver side drive axle assembly by myself. : Took 2 hours. I used a chisel to pry the axle out of the transmission block : . I also used 2 bungee cords to hang the rotor/steering knucle. : Depending on your car, you may not need to remove ball joint. I did not : remove mine. You also need a torque wrench. : My CV boot was broken. I did not bother to replace the boot. Just replace : the whole axle. The new axle is made by A1 cardone (high quality). The : axle costed me $93.
|
z****g 发帖数: 2128 | 8 engine mounts排除
wheel alignement and balancing,排除
只要上坡,加速的时候,同时还是50左右范围的时候抖动,rpm也较为高,1800-2500这
样.
看了n多人的回复,非常大可能是axle。同时我的车子也快140K miles了。估计前owner
也没有换过。所以想搞一下。
如果自己搞麻烦,我就去联系shop了,算到6月份的DIY/维护了
【在 d***8 的大作中提到】 : 你这太搞了。 : 有无数原因引起震动,换axle是最难搞的一个原因。
|
d***8 发帖数: 2039 | 9 你查brake rotor 和pads。要小心查。 |
z****g 发帖数: 2128 | 10 我刚换过brake rotor和pads,呵呵。
所以这个也排除。
而且这个症状在我没换brake的时候就有了,一般只有跑高速我才能感觉到,我平时很
少跑高速,所以也懒的理
7月份打算东边走一圈,所以为了安全起见,还是得折腾一下。
【在 d***8 的大作中提到】 : 你查brake rotor 和pads。要小心查。
|
d***8 发帖数: 2039 | 11 Transmission mounts和enginemounts,即使看不出wear and tears,也因该换换了。
会有很大的改善。140K miles。
owner
【在 z****g 的大作中提到】 : engine mounts排除 : wheel alignement and balancing,排除 : 只要上坡,加速的时候,同时还是50左右范围的时候抖动,rpm也较为高,1800-2500这 : 样. : 看了n多人的回复,非常大可能是axle。同时我的车子也快140K miles了。估计前owner : 也没有换过。所以想搞一下。 : 如果自己搞麻烦,我就去联系shop了,算到6月份的DIY/维护了
|
z****g 发帖数: 2128 | 12 恩,这个目前先不搞,搞最要紧的先。
拉着刹车,让朋友加油,D5和R都试过了,我看到引擎位移不大,不是engine mount的
问题。side engine mount也仔细看过。
【在 d***8 的大作中提到】 : Transmission mounts和enginemounts,即使看不出wear and tears,也因该换换了。 : 会有很大的改善。140K miles。 : : owner
|
h****y 发帖数: 9234 | 13 在确定原因之前不要乱换
throw parts at your car is not a good way to repair it.
【在 z****g 的大作中提到】 : 不是,就是开车的时候,40-60mph的时候 : 加速的时候,车子震动明显。 : 看网上说80%是axle坏了。
|
z****g 发帖数: 2128 | 14 非常确定是它了。只是左边还是右边的问题,或者两个都是。
因为我的油门,有时候也有小小的震动(车子不振的时候)。
【在 h****y 的大作中提到】 : 在确定原因之前不要乱换 : throw parts at your car is not a good way to repair it.
|