S****o 发帖数: 503 | 2 If the inner hex on the pulley is too deep. You can add a nipple (yeah, tha's
the name of it, a short pipe with male thread on both end) and a coupling (a
connector with female thread) between the tee and the reducer (this should be
the correct name of the adapter with hex head, but some reducers don't have
hex heads, they may have octangle heads or just round).
But many cars (like mine) don't have such inner hex on the pulley for a
special tool.
个
.
【在 s****m 的大作中提到】 : 我昨天换TB文中提到的. 很难描述清楚. : 终於把照片放到PBASE了. hoho : http://www.pbase.com/cbull/inbox
|