i****a
发帖数: 36252 | 1 說說我的設置
肥P -> HDMI -> Onkyo 接收器 -> HDMI -> TV
肥P bluray Setting, set audio to Linear PCM
肥P audio setting (not under bluray), 掛鉤接收器後, 未知原因它沒有自動撿起新
的輸
出, 仍在 2.1. 難怪接收器一直不能設置為 multi Channel, 也感覺環繞聲不夠好. 重刷一
下，確保檢測到 5.1, 仍設置為自動就好.
可參考
http://hd.engadget.com/2009/04/21/hd-101-how-to-use-dolby-truehd-and-
dts-hd-with-your-ps3/2
Onkyo 設置:
昨晚終於有時間調不同配置
揚聲器的距離:基於實際距離
volume: have all speakers at about the same loudness
Audyssey: On
Dynamic EQ: On
Reference level: 15dB
DynamicVolume: Light
其他設置不會影響 LPCM 播放
用了 終端子 4，救恩 (terminator 4, salvation) 來測試, 效果不錯. 清晰度不夠好.
Dynamic EQ and Volume 是一大原因. 為什麼用？ 見下.
說說 Dynamic EQ and Dynamic Volume. I am confused on what the difference
is. D EQ must be on to have D V. When D V is turned on, they help a lot
when I cannot turn the volume up to clearly hear the whisper dialog
without shaking the apartment walls during explosions.
I think it is over boosting even at the lowest level "light" but not to
an annoying level. I set reference level to 15dB because I felt it had
the lowest level of boost.
And I can't figure out exactly what D EQ and the reference level do even
after reading the manual 3 times.
■Dynamic EQ
Off:
Audyssey Dynamic EQ off.
On:
Audyssey Dynamic EQ on.
The “Dynamic EQ” indicator will light (➔ 8).
With Audyssey Dynamic EQ™, you can enjoy great
sound even when listening at low volume levels.
Audyssey Dynamic EQ solves the problem of deteriorating
sound quality as volume is decreased by taking
into account human perception and room acoustics. It
does so by selecting the correct frequency response and
surround volume levels moment-by-moment so that the
content sounds the way it was created at any volume
level — not just at reference level.
Note
• The setting is stored individually for each input selector.
■Reference Level
Audyssey Dynamic EQ™ Reference Level Offset
0 dB:
It should be used when listening to movies.
5 dB:
Select this setting for content that has a very wide
dynamic range, such as classical music.
10 dB:
Select this setting for jazz or other music that has a
wider dynamic range. This setting should also be
selected for TV content as that is usually mixed at
10 dB below film reference.
15 dB:
Select this setting for pop/rock music or other program
material that is mixed at very high listening
levels and has a compressed dynamic range.
Movies are mixed in rooms calibrated for film reference.
To achieve the same reference level in a home theater
system each speaker level must be adjusted so that
–30 dBFS band-limited (500 Hz to 2000 Hz) pink noise
produces 75 dB sound pressure level at the listening
position. A home theater system automatically calibrated
by Audyssey EQ will play at reference level
when the master volume control is set to the 0 dB position.
At that level you can hear the mix as the mixers
heard it.
Audyssey Dynamic EQ is referenced to the standard
film mix level. It makes adjustments to maintain the reference
response and surround envelopment when the
volume is turned down from 0 dB. However, film reference
level is not always used in music or other non-film
content. Audyssey Dynamic EQ Reference Level Offset
provides three offsets from the film level reference
(5 dB, 10 dB, and 15 dB) that can be selected when the
mix level of the content is not within the standard. | z*********n
发帖数: 94654 | 2 瘦P好多了，没那么多烦恼
【在 i****a 的大作中提到】
: 說說我的設置
: 肥P -> HDMI -> Onkyo 接收器 -> HDMI -> TV
: 肥P bluray Setting, set audio to Linear PCM
: 肥P audio setting (not under bluray), 掛鉤接收器後, 未知原因它沒有自動撿起新
: 的輸
: 出, 仍在 2.1. 難怪接收器一直不能設置為 multi Channel, 也感覺環繞聲不夠好. 重刷一
: 下，確保檢測到 5.1, 仍設置為自動就好.
: 可參考
: http://hd.engadget.com/2009/04/21/hd-101-how-to-use-dolby-truehd-and-
: dts-hd-with-your-ps3/2
| i****a
发帖数: 36252 | 3 如果我發到 HiFi 版 會不會被 B4 ... 設備太入門級 | z*********n
发帖数: 94654 | 4 肯定会的，首先会被metrosexual的完少嘲笑
【在 i****a 的大作中提到】
: 如果我發到 HiFi 版 會不會被 B4 ... 設備太入門級
| T*********e
发帖数: 39815 | 5 会，呵呵
【在 i****a 的大作中提到】
: 如果我發到 HiFi 版 會不會被 B4 ... 設備太入門級
| i****a
发帖数: 36252 | 6 今晚看能不能 享受一下 Gattaca, Contact 或最終幻想 |
|
