G****A 发帖数: 4160 | 1 latex => PS 老是报错“.ps file does not exist!”, latex=>pdf就好好的。
GSview本身没问题,GHOSTSCRIPT也装了。
下面是我的latex=>PS 设置: |
k**f 发帖数: 372 | 2
The ps file is generated using dvips over the dvi file generated by latex.
I suppose you are using TeXniccenter. In the output definition dialog box,
check the "Postprocessor" panel, make sure that the path of dvips is set
properly. The argument should be "%Bm.dvi".
【在 G****A 的大作中提到】 : latex => PS 老是报错“.ps file does not exist!”, latex=>pdf就好好的。 : GSview本身没问题,GHOSTSCRIPT也装了。 : 下面是我的latex=>PS 设置:
|
G****A 发帖数: 4160 | 3 多谢,果然dvips路径不对。重新设置就好了。
对了,再问一下。我在一台新机器上刚刚装了MikTex + TeXniccenter. 拿来一个IEEE
的sample tex file, 编译后竟然提示15个错误。很多:"Undefined control sequence
!"
这是什么意思?他没提示缺少package阿!
【在 k**f 的大作中提到】 : : The ps file is generated using dvips over the dvi file generated by latex. : I suppose you are using TeXniccenter. In the output definition dialog box, : check the "Postprocessor" panel, make sure that the path of dvips is set : properly. The argument should be "%Bm.dvi".
|
k**f 发帖数: 372 | 4
IEEE
sequence
What are the commands (control sequences) in question? In the tex file or in
the package?
【在 G****A 的大作中提到】 : 多谢,果然dvips路径不对。重新设置就好了。 : 对了,再问一下。我在一台新机器上刚刚装了MikTex + TeXniccenter. 拿来一个IEEE : 的sample tex file, 编译后竟然提示15个错误。很多:"Undefined control sequence : !" : 这是什么意思?他没提示缺少package阿!
|
G****A 发帖数: 4160 | 5 latex sample file 是我从infocom 2009上下的,我把错误的log贴出来,帮我看看吧。
已经搞了好久了。 |
k**f 发帖数: 372 | 6
吧。
I just downloaded the sample file
http://www.ieee-infocom.org/Infocom09_sample.tex
and unzipped all the files from
http://www.ieee.org/portal/cms_docs_iportals/iportals/publications/pubservices/confpub/auxfiles/IEEEtran5.zip
and
http://www.ieee.org/portal/cms_docs_iportals/iportals/publications/pubservices/confpub/auxfiles/IEEEtranBST2.zip
into the same directory as the sample tex file.
Running MikTeX 2.7 from withing TeXnicCenter, there's no error or warning,
just one bad box due to a URL
【在 G****A 的大作中提到】 : latex sample file 是我从infocom 2009上下的,我把错误的log贴出来,帮我看看吧。 : 已经搞了好久了。
|