s********k 发帖数: 6180 | 1 AC sense channel busy之后,会在1.6.11三个频段时间switch吗?觉得好像是的 |
g******s 发帖数: 410 | 2 好像没有吧
【在 s********k 的大作中提到】 : AC sense channel busy之后,会在1.6.11三个频段时间switch吗?觉得好像是的
|
s********k 发帖数: 6180 | 3 这个不算是传统意义上channel hopping(PHY)的,但是属于上层控制channel?
【在 g******s 的大作中提到】 : 好像没有吧
|
s*****t 发帖数: 987 | |
g******s 发帖数: 410 | 5 I think he means frequency diversity or collision avoidance. But I really do
n't know whether this is required in 802.11b/g system.
【在 s*****t 的大作中提到】 : 啥是channel hop? : 调频?
|
s********k 发帖数: 6180 | 6 不是collision avoidance,那个当然有,就是CSMA,我意思是比如wifi在北美最主要
的3个channel, 1,6,11, 如果探测到channel 1 非常多traffic,AP有没有可能自动
选择到channel 6?
do
【在 g******s 的大作中提到】 : I think he means frequency diversity or collision avoidance. But I really do : n't know whether this is required in 802.11b/g system.
|
g******s 发帖数: 410 | 7 According a few wireless routers I've ever used, I think the answer is no, i
.e. they will only communicate on the channel specified in the firmware (def
ault is 6 I think). As to other APs, I guess channel/frequency hopping may b
e supported. After all they can measure somewhat like carrier-to-interferenc
e ratio and adapt to the wireless environment. But that can only happen at s
tartup, right? Since you cannnot require other client nodes (this may be not
the correct term, forgive me I'm some time away from wireless) hopping the
frequency during communication.
So, the bottom line is channel can be hopped but both ends should support th
at. I guess channel hopping is not "required" in the specification of 802.11
b/g. Hopping "may be" suggested or recommended, but due to cost or whatever
reasons, most wireless cards don't support hopping.【 在 silverhawk (
silverhawk) 的大作中提到: 】 |
z*****b 发帖数: 1016 | 8 我做过干扰测试,使用3个不同厂家芯片的WIFI device, 干扰用的iperf.
如果干扰大的话,有两种情况:
1)CSMA检测后,调到别的ch
2)link drop. device一段时间会再尝试连接。 |
s********k 发帖数: 6180 | 9 谢谢,CSMA之后按道理是不会有channel hopping的,因为这个是MAC layer,你有没有
用WLAN controller之类的?另外是802.11g吗?
【在 z*****b 的大作中提到】 : 我做过干扰测试,使用3个不同厂家芯片的WIFI device, 干扰用的iperf. : 如果干扰大的话,有两种情况: : 1)CSMA检测后,调到别的ch : 2)link drop. device一段时间会再尝试连接。
|
z*****b 发帖数: 1016 | 10 是802.11g,会跳的是学校wifi网络,会从2.4GHz跳到5GHz。。。
你说的WLAN controller是什么? AP嘛? |
s********k 发帖数: 6180 | 11 哦,从2.4G到5G和我说的有点不一样,我记得只有很少部分用5G,比如802.11ac之类。
我的意思是在2.4G上有3个频段,会不会在之间hopping。WLAN controller不是AP,应
该主要是企业级别的用,比如大学或者办公楼里面统一部署这些wifi AP,做统一的网络
规划,当然包括就是频率规划 |
z*****n 发帖数: 7639 | 12 no,你跳了,transmitter不跳,你收啥东西啊?
【在 s********k 的大作中提到】 : AC sense channel busy之后,会在1.6.11三个频段时间switch吗?觉得好像是的
|
z*****n 发帖数: 7639 | 13 你这就不叫hopping了。上层发现throughput不行了
换channel是可以的,但是要所有的transceiver
都同意/知道才行。
【在 s********k 的大作中提到】 : 这个不算是传统意义上channel hopping(PHY)的,但是属于上层控制channel?
|