b****a
发帖数: 460 | 1 按照板上大神的刷机指南刷机。
第一步降级firmware需要进入recovery mode
Enter Recovery Mode:
* Turn power off to the router by disconnecting the power cable & Wait 10
seconds
* Press and hold the RESET button & Restore power to router while continuing
to hold RESET button
* Continue to hold RESET button for 20 seconds then release RESET and wait
till the router fully boot
上电之后hold reset 远超过20秒，就是不见LED或者power led闪烁（开机之后一直长
亮但不闪烁）。用firmware restoration也提示说router is not under rescue mode。
各位知道为什么无法进入recovery mode吗？
断电我尝试了直接断开和电源线和按电源按钮，效果一样。
IP地址设置没有问题，因为浏览器输入192.168.29.1能够正常进入神油设置页面 | I*******g
发帖数: 7600 | 2 T给锁住了。
continuing
【在 b****a 的大作中提到】
: 按照板上大神的刷机指南刷机。
: 第一步降级firmware需要进入recovery mode
: Enter Recovery Mode:
: * Turn power off to the router by disconnecting the power cable & Wait 10
: seconds
: * Press and hold the RESET button & Restore power to router while continuing
: to hold RESET button
: * Continue to hold RESET button for 20 seconds then release RESET and wait
: till the router fully boot
: 上电之后hold reset 远超过20秒，就是不见LED或者power led闪烁（开机之后一直长
| t**********a
发帖数: 2869 | 3 你这个固件版本可能比较新，试试下面方法：
1) holding down three buttons- reset, WPS, and wifi on/off - all at the same
time
2) powering on
3) waiting a few seconds for fast blinking lights
4) releasing the WPS and wifi buttons, but still holding down reset,
5) as soon as 192.168.29.1 started answered pings, quickly visiting http://192.168.29.1/ to open the mini CFE uploader,
6) submitting the 1703 firmware, and waiting for upload success message
7) finally releasing the reset button. | b****a
发帖数: 460 | 4 好的 非常感谢。
same
【在 t**********a 的大作中提到】
: 你这个固件版本可能比较新，试试下面方法：
: 1) holding down three buttons- reset, WPS, and wifi on/off - all at the same
: time
: 2) powering on
: 3) waiting a few seconds for fast blinking lights
: 4) releasing the WPS and wifi buttons, but still holding down reset,
: 5) as soon as 192.168.29.1 started answered pings, quickly visiting http://192.168.29.1/ to open the mini CFE uploader,
: 6) submitting the 1703 firmware, and waiting for upload success message
: 7) finally releasing the reset button.
|
|
