X***n 发帖数: 134 | 1 为什么强度要求最大的房子的frame用钉子,橱柜用螺丝,要求最低的trim又用钉子?
究竟钉子和螺丝哪个更强?如果跟钉子粗细有关的话为什么橱柜不用相应中等尺寸长度
的钉子? |
m*f 发帖数: 3078 | |
m*f 发帖数: 3078 | 3 http://diy.stackexchange.com/questions/2568/why-should-i-use-ad
It is all about time. In this case, the time required to drive a screw,
instead of the time to drive a nail with a loaded nail gun. Drive 10 screws,
and who cares if it takes a few seconds longer to drive each screw. Drive
10,000 screws, and it starts to matter. |
m*f 发帖数: 3078 | 4 Another big reason:
Screws are brittle and can't withstand the stress of a shear loaded joint,
so use of nails is necessary simply because screws will fail in that
application (and are required by building code).
The only proper fastener besides a nail would be a bolt - and that would
take even longer (and cost far more) than driving a framing nail.
And just like woodchips said above, speed/cost is a big factor - I can drive
20 nails with my framing nailer in the time you can run a pair of 3" screws
into a stud. |
X***n 发帖数: 134 | |
m*f 发帖数: 3078 | 6 看不见的地方上nailer也是有的
【在 X***n 的大作中提到】 : 谢了。怎么解释为什么橱柜一般不用钉子。
|
m*****3 发帖数: 13701 | 7 葱白-ing!
【在 m*f 的大作中提到】 : 看不见的地方上nailer也是有的
|
m*f 发帖数: 3078 | 8 客气了,我就胡说一下
【在 m*****3 的大作中提到】 : 葱白-ing!
|
m*****3 发帖数: 13701 | 9 大牛太谦虚啦,您说的俺向来直接当作真理。
【在 m*f 的大作中提到】 : 客气了,我就胡说一下
|
T*U 发帖数: 22634 | 10 容易拆,不然一用翘棍,就破相了。
【在 X***n 的大作中提到】 : 谢了。怎么解释为什么橱柜一般不用钉子。
|
T*U 发帖数: 22634 | 11 frame都有互相支撑的,橱柜都是悬空墙上的。
【在 X***n 的大作中提到】 : 为什么强度要求最大的房子的frame用钉子,橱柜用螺丝,要求最低的trim又用钉子? : 究竟钉子和螺丝哪个更强?如果跟钉子粗细有关的话为什么橱柜不用相应中等尺寸长度 : 的钉子?
|
s**********d 发帖数: 36899 | 12 是啊,frame是木头受力,钉子是辅助而且只收剪切力。
橱柜所有重力都在钉子上,而且由于重心在外,有一个往外拔的力。
如果在坐的地上的橱柜,有的可以用钉子。 |
c****o 发帖数: 32446 | |